Prepare The Hood; Measure The Installation - Broan B5630SS Manual De Instrucciones

Ocultar thumbs Ver también para B5630SS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SR - N
MODELS
B5630SS
• B5636SS
• B5730SS
• B5736SS
INSTALL
THE DUCTWORK
Page2
(Ducted
Hoods Only)
PREPARE
THE HOOD
1. Decide where
the ductwork
will run
between the
hood and the
outside.
2. A straight, short
duct run will
allow the hood
to perform most
efficiently.
3. Long duct
runs, elbows
and transitions
will reduce the
performance of
ROOF
CAP
\
6"
DUCT
HOOD
DECORATIVE
FLUE
30"TO
36"ABOVE
COOKING
SURFACE
ROUND
ELBOW
the hood. Use as few of them as possible. Larger ducting
may be required for best performance with longer duct runs.
4. Install wall cap or roof cap. Connect round metal ductwork
to cap and work back towards the hood location. Use duct
tape to seal the joints between ductwork sections.
MEASURE
THE INSTALLATION
ROOF CAP
/
__'_"'_
_
ROUND ELBOW
6ROOND
DUOT --fl
_
WALL
CAP
r-F,/
DECORATIVE
FLUE _
I
_3_,.-
m \
HOOD MOUNTING
_
_
_
.J_'/
BRACKET
HOOD
II
I
I
t
I_---_
12 1/2" TO CENTER
3%" --
_
,
"
-'- t
30" TO36" ABOVE
COOKING
SURFACE
*
I
Unpack hood and check contents. You should receive:
1 - Hood
1 - Glass Canopy (Models B5630SS & B5636SS)
1 - Metal Canopy (Models B5730SS & B5736SS)
1 - Decorative Flue Assembly
1 - Damper / Duct Connector
1 - Lower Flue Mounting Bracket
1 - Upper Flue Mounting Bracket
1 - Hood Mounting Bracket
2 - Aluminum Grease Filters (installed in hood)
1 - Parts Bag containing:
8 - Mounting Screws (#8 x 3/8" Pan Head)
7 - Mounting Screws (#8 x 1-1/2" Flat Head)
4 - Mounting Screws (M4 x 1.0 Flat Head)
7 - Drywall Anchors
2 - Washers
4 - Decorative Washers
1 - Installation Manual
J
DECORATIVEFLUE
DAMPER/ DUCT
CONNECTOR
_(_M
OUNTING
CREWS
4X 1.0"
at Head)
7 MOUNTING
SCREWS
(#8 X 1-1/2"
FlatHead)
FLUEMOUNTING
BRACKET
8 MOUNTING
SCREWS
(#8 x 3/8"
Pan Head)
2 WASHERS
7 DRYWALL
ANCHORS
4 DECORATIVE
WASHERS
LOWER
FLUE MOUNTING
BRACKET
HOOD
MOUNTING
BRACKET
The minimum
hood distance above cooktop MUST NOT BE
LESS than 30".
A maximum of 36" above cooktop is highly recommended
for
best capture of cooking impurities.
Distances
over 36" are at the installer and users discretion;
providing that the ceiling height permits.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

B5636ssB5730ssB5736ss

Tabla de contenido