4. Attach the hose Connector, screw
down sufficiently to tighten the
seal but do not over tighten.
5. Assemble the three stakes and
attach to bottom of unit body.
6. Connect hose and position the
sprinkler, Choose the location you
want to protect.
5. Sensitivity Guide
1. Setting 0 (full anti-clockwise) places
the controller in stand-by mode and it
will not activate.
2. Setting 1 to 7 progressively increases
the range of detection.
3. Setting 8 (fully clockwise) selects
night-time only operation (for noc-
turnal animals), setting 8 has the
same detection range as setting 7.
Note: the solar panel must be connected for device to sense
it is night-time.
6. A djusting Spray Coverage
1. Select a hose in a good condition with no leaks. Water
pressure will decrease with increasing hose length and this
may reduce spray coverage. Check operation with a short
hose to become familiar with performance at good opera-
ting pressure .
2. Before attaching the hose to the Hose Quick Connector,
always remember to flush the hose to remove debris that
may damage the Controller or Filters. For example, small
stones ,dirt, ants etc. Flushing the hose will also remove
air pockets so the deterrent will spray properly .
3. After attaching hose, turn ON water. Your tap must be fully
on for correct operation of the sprinkler.
4. Set the Range Control to 6 or 7 .
5. Stand behind or to the side of the Sprinkler and slow-
ly move your hand about 1m in the front of the Motion
Sensor to activate the Sprink-
ler. Check the angular range of
the spray and adjust (see 1 &
2)the left and right stoppers.
Adjust the Sprinkler to send wa-
ter toward the area viewed by the
Sensor.
6. Activate the Sprinkler as in Step 3.
Adjust the distance of the spray
by rotating the knob 5 on the top
of the Sprinkler. Spray distance
may also vary with your hose wa-
ter pressure.
7. Before disconnecting the hose
from the Controller, turn water
OFF and activate the Controller
with you hand to depressurize
the hose .
7. W orking principle
Range 3 m: Settings 5 – 6
Range 6 m: Settings 6 – 7
Small animals
Range 3 m: Settings 3 – 4
Range 6 m: Settings 5 – 6
Medium animals
Range 10 m: Settings 6 – 7
Range 3 m: Settings 1 – 3
Range6 m: Settings 5 – 6
Range 10 m: Settings 6 – 7
Large animals
1. Attach sprinkler head by head to the top of Unit body by
turning clockwise.
7