Ryobi P3650 Manual Del Operador página 12

MOUNTING HOLES
See Figure 7.
WARNING:
Before starting any cutting operation, clamp or bolt your
miter saw to a workbench or an approved miter saw stand.
If a miter saw stand is used, read operator's manual and
follow the instructions for the miter saw stand. Never
operate your miter saw on the floor or in a crouched
position. Failure to heed this warning can result in serious
personal injury.
The compound miter saw should be mounted to a firm
supporting surface such as a workbench, mounting board,
or miter saw stand. The saw base has four mounting
holes. If using bolts, they should be of sufficient length to
accommodate the saw base, lock washers, hex nuts, and
the thickness of the workbench or other mounting surface.
Tighten all bolts or screws securely.
The hole pattern for mounting to a workbench is shown in
Figure 7. Carefully check the workbench after mounting to
make sure that no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the workbench
to the floor before operating.
LOCKING/UNLOCKING THE SAW ARM
See Figure 8.
To unlock and raise the saw arm:
 Firmly grasp the "D" handle and push down against the
stop.
 Pull the lock pin out and away from the saw housing.
 Slowly raise the saw arm.
To lock the saw arm:
 Firmly grasp the "D" handle and push down against the
stop.
 Push the lock pin in toward the saw housing.
 Release the saw arm.
DUST BAG
See Figure 9.
A dust bag is provided for use on this miter saw. It fits over
the exhaust port on the back of the saw.
NOTE: The exhaust port also accepts 1-1/4 in. vacuum hose.
ASSEMBLY
LOCK
PIN
12 − English
DUST
BAG
EXHAUST
PORT
"D"
HANDLE
Fig. 8
Fig. 9