Ryobi P3650 Manual Del Operador página 14

TO INSTALL/REPLACE THE BLADE
See Figures 12 - 13.
WARNING:
A 10 in. blade is the maximum blade capacity of the saw.
Never use a blade that is too thick to allow outer blade
washer to engage with the flats on the spindle. Larger
blades will come in contact with the blade guards, while
thicker blades will prevent the blade bolt from securing
the blade on the spindle. Either of these situations
could result in a serious accident and can cause serious
personal injury.
 Remove the battery packs from the tool.
 Loosen blade bolt cover screw. Rotate lower blade guard
and blade bolt cover up and back to expose the blade
bolt.
 Depress the spindle lock button and rotate the blade bolt
until the spindle locks.
 Using the blade wrench provided, loosen and remove the
blade bolt.
NOTE: The blade bolt has left hand threads. Turn blade
bolt clockwise to loosen.
 Remove the outer blade washer.
 Wipe a drop of oil onto inner blade washer and outer
blade washer where they contact the blade.
 Fit saw blade inside lower blade guard and onto spindle.
The blade teeth point downward at the front of saw as
shown in Figure 13.
 Replace the outer blade washer. Double "D" flats on blade
washers align with flats on spindle.
 Depress spindle lock button and replace blade bolt.
NOTE: The blade bolt has left hand threads. Turn blade bolt
counterclockwise to tighten.
CAUTION:
Always install the blade with the blade teeth and the arrow
printed on the side of the blade pointing down at the front
of the saw. The direction of blade rotation is also stamped
with an arrow on the upper blade guard.
 Tighten blade bolt securely.
 Replace the lower blade guard and blade bolt cover.
 Securely tighten the blade bolt cover screw.
 Raise and lower the saw head and ensure that the lower
blade guard operates properly.
ASSEMBLY
NOTE: BEFORE USE,
REPLACE SCREWS AND
TIGHTEN SECURELY
TO PREVENT GUARD
MOVEMENT
BOLT COVER
OUTER BLADE
WASHER
WITH DOUBLE
"D" FLATS
LOOSEN
BLADE
BOLT
14 − English
OUTER
BLADE
WASHER
BLADE
BOLT
BLADE
BOLT COVER
SCREW
LOWER BLADE
GUARD
BLADE
TO
TO
TIGHTEN
SPINDLE
LOCK BUTTON
Fig. 12
BLADE
FLAT(S)
ON SPINDLE
BLADE
Fig. 13