V
PROBLEM
Make sure the lint filter is cleaned before every load. With some loads that
produce high amounts of lint, it may be necessary to clean the filter during the
cycle.
Some fabrics are lint producers (for example, a fuzzy white cotton towel)
Lint on clothes
and they should be dried separately from clothes that are lint trappers (for
example, a pair of Eacklinen pants)
Divide larger loads into smalEer loads for drying.
Check pockets thoroughly
before washing and drying clothes.
Garments
still wrinkled
Small loads of I to 4 items work best.
afterWrinkle-Care
Load fewer garments.Load
similar-type
garments.
Odors remain in
Fabrics
containing
strong odors should
be dried in a normal cycle.
clothing
after Refresh.
Water drips from
This is steam condensation.The
dripping
water will stop after a short time.
nozzle when Steam-
Care starts
Sprayed water
is not
Sprayed water is difficult to see when the door is closed.
visible
during
Steam-
Care
Extended
time
Verify correct
loading
(clothes)/cycle
selection
(see page 23).
Znfopmation codes
Information
codes may be displayed to help you better understand
what is occurring
with your Dryer.
l
The thermistor
resistance is very low
J
tE
j
or high.
invalid heating Temp when the dryer
Call for service.
j
liE
i
is running.
M
!
i
i
J
Clean the door and then restart.
The door is open.
If the problem
continues, call for service.
-----Invalid
state of key.
' lViake sure a button is NOT being pressed
'
continuously. Try restarting the cycle.
i
If the problem
continue, call for service.
_
,
i
Invalid power source frequency.
Try restarting the cycle.
If the problem
continues, call for service.
l
I
i
Electronic Control Problem
Call for service.
i1
91:1
(OverVoltage
Error.)
Electronic Control Problem
Call for service.
j
_
Communication
Error.)
i
Invalid state of Eeprom
Call for service.
communication.
Invalid door.
Call for service.
For any codes not listed above, call 1-800-SAMSUNG (726-7864)
English _34
DV425000
DO68-O3381Aindd
34
2013-12-19
D_
1:07:16