Maintaining The Spark Plug - Sears Craftsman 316.990100 Manual De Uso

MAiNTAiNiNG THE SPARK PLUG
1. Stop the engine and allow it to cool. Grasp the spark plug boot
firmly and pull it from the spark plug.
2. Clean around the spark plug. Remove the spark plug from the
cylinder head with a 5/8-inch socket, turning counterclockwise.
_ WARNING:
Do not sand blast, scrape or clean spark plug
|
electrodes. Grit in the engine could damage the cylinder.
3. inspect the spark plug. If the spark plug is cracked, fouled or
dirty, replace it with a replacement part #753=06193, a
Champion RDJ7J or an equivalent spark plug.
4. Use a feeler gauge to set the air gap at 0.025 in. (0.635 ram}
(Fig. 21).
5. install the spark plug in the cylinder head. Tighten the spark plug
with a 5/8-inch socket, turning it clockwise until snug.
NOTE: If using a torque wrench, torque to:
110-120 in..lb. (12.3-13.5 Nora}. Do not over tighten.
6. Reattach the spark plug boot.
0.025 in.
(0.635 ram}
\
Fig. 21
16