Holding The Trimmer - Sears Craftsman 316.990100 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HOLDING
THE TRIMMER
_
WARNING:
Always wear eye, hearing, hand, foot and
i
body protection to reduce the risk of injury when operating
J
this unit.
Stand in the operating position (Fig. 9).
Hold the shaft grip with the right hand. Keep the right arm
slightly bent.
Hold the handle with the left hand. Keep the left arm straight.
Hold the unit at waist level.
,_
Keep the cutting head parallel to the ground so that it easily
_
,_
contacts the grass without the need for bending over.
Fig. 9
ADJUSTING THE TRiMMiNG
LiNE LENGTH
This unit is equipped with a Bump Head. Trimming line can be
released from the cutting head without stopping the engine.
To release more line, lightly tap the bump knob on the ground (Fig. 10)
while operating the unit at high speed. For best results, tap the bump
knob on bare ground or hard soil. Attempting to release line in tall
grass may stall the engine.
NOTE: Do not rest the cutting head on the ground while the unit is
running.
Each time the bump knob is tapped, about 1 inch (25.4 mm) of
trimming line is released.
NOTE: Always keep the trimming line fully extended. Line release
becomes more difficult when the cutting line gets shorter.
A blade in the cutting head shield will cut the line to the proper
length if any excess line is released.
CAUTION:
Do not remove or alter the line cutting blade
assembly. Excessive line length will make the unit
overheat. This may lead to serious personal injury or
damage to the unit.
Bump Knob
Fig. 10
TiPS FOR BEST TRiMMiNG
RESULTS
Keep the cutting head parallel to the ground.
Cut from left to right whenever possible. This improves the unit's
cutting efficiency and throws clippings away from the operator.
Do not trim wet grass or weeds.
NOTE: Some line breakage will occur from:
Entanglement with foreign matter
Normal line fatigue
Attempting
to cut thick vegetation
Forcing the line into objects such as walls or fence posts
DECORATIVE
TRiMMiNG
When trimming around trees, posts, fences, etc., rotate the whole
unit so that the cutting head is at a 30 ° angle to the ground (Fig. 11).
3
Fig. 11
12

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Craftsman weedwacker

Tabla de contenido