Attaching The Arm Cuff; How To Take Proper Measurements; Measurement; After Measurement - A&D UA-767 Plus Manual De Instrucciones

Attaching The Arm Cuff

1. Wrap the cuff around the upper
arm, about 2 - 3 cm above the
elbow, as shown. Place the cuff
directly against
clothing may cause a faint pulse,
and result in a measurement error.
2. Constriction of the upper arm,
caused by rolling up a shirtsleeve,
may prevent accurate readings.

How To Take Proper Measurements

For the most accurate blood
pressure measurement:
Sit comfortably at a table.
Rest your arm on the table.
Relax for about five to ten minutes
before measurement.
Place the center of the cuff at the same height as your heart.
Remain still and keep quiet during measurement.
Do not measure right after physical exercise or a bath. Rest for twenty or
thirty minutes before taking the measurement.
Try to measure your blood pressure at the same time every day.

Measurement

During measurement, it is normal for the cuff to feel very tight. (Do not be
alarmed)

After Measurement

After measurement, press the
Remove the cuff and record your data.
Note: The device has an automatic power shut-off function, which turns the
power off approximately one minute after measurement.
Allow at least ten minutes between measurements on the same person.
Using the Monitor
the skin, as
English 7
Rolling up shirtsleeve
Constriction of the Upper Arm
button to turn off the power.
START
Air Hose
2 -3 cm