Stihl SE 62 Manual De Instrucciones página 26

English
Route the power cord and extension
cord properly:
Observe the minimum cross-section
–
of the individual cords – see
"Connecting the machine to the
power supply"
Route and mark the power cord so
–
that it cannot become damaged and
no one is endangered – danger of
stumbling!
The connector and coupling of the
–
extension cord must be waterproof
or routed in such a way that they
cannot come into contact with water
– the connector and coupling of the
extension cord must not lie in water
don't let the cord rub against edges
–
or pointed or sharp objects
don't squeeze the cord under doors
–
or windows
if cords become snarled – unplug
–
the power plug and unsnarl the cord
always unroll the power cord from
–
the cable reel completely to avoid
risk of fire due to overheating
During Operation
If the power cord is dam-
aged, immediately
disconnect the plug from
the wall outlet – risk of
electric shock!
24
Ensure that the power cord is not
damaged by being driven over,
squashed or pulled, etc.
Never unplug the power plug by pulling
on the cord: always grip the plug itself.
The power cord and power plug must
never be touched with wet hands.
Never spray electrical devices with
water – Danger of short-circuiting!
In the event of imminent danger or in an
emergency – move switch to 0 .
Never let the machine run unattended.
Do not leave the machine outdoors in
the rain.
The machine may only be operated in an
upright position. Do not cover the
machine and ensure adequate motor
ventilation.
Ensure that the filter element is always
undamaged.
If foam develops or liquid escapes, stop
work immediately, unplug the power
cord, and empty the container.
If the machine is subjected to unusually
high loads for which it was not designed
(e. g., heavy impact or a fall), always
check that it is in good condition before
continuing work - refer also to the
chapter "Before starting work". Also
make certain that the safety
mechanisms are working properly.
Never continue using a machine that is
not in perfect working order. In case of
doubt, have the unit checked by your
servicing dealer.
Before leaving the machine unattended:
Switch off the machine – unplug the
power cord.
After Finishing Work
Unplug the power plug from the socket
Never unplug the power plug by pulling
on the cord: always grip the plug itself.
Always clean dust and dirt off the
machine – do not use any grease
solvents for this purpose.
Maintenance and Repairs
Before carrying out any
work on the power tool:
Disconnect the plug from
the power supply.
Service the machine regularly. Do not
attempt any maintenance or repair work
not described in the instruction manual.
Have all other work performed by a
servicing dealer.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer. STIHL dealers are
regularly given the opportunity to attend
training courses and are supplied with
the necessary technical information.
SE 62, SE 62 E