Mounting The Controller - Rain Bird ESP Guía De Instalación, Funcionamiento Y Programación

II. MOUNTING THE CONTROLLER
1
2
1. Install appropriate fastener for type of wall for keyhole
1
slot. Hang the controller by the keyhole slot.
2. Level the controller & mark position(s) of one or more
2
of the lower mounting hole(s).
3
1. Drive the appropriate fastener(s) into the lower
3
mounting hole(s). Verify that the cabinet is secure.
Rain Bird ESP Modular Controller
®
III. WIRING - POWER
2
1
3
230 VAC
Fits 1,3cm conduit fittings
4
4 Using code-approved wire connector,
connect the wires:
• Brown to Brown
• Blue to Blue
• Green/Yellow to Green/Yellow
Note: The green/yellow ground wires MUST
be connected to provide additional electrical
surge protection.
Installation, Programming and Operation Guide 51