Rain Bird ESP Guía De Instalación, Funcionamiento Y Programación página 65

TROUBLESHOOTING
SYMPTOM
Display is partially or completely
blank.
Watering starts when it should
not.
64 Installation, Programming and Operation Guide
POSSIBLE CAUSE
10.The sensor system is preventing irrigation.
11.Start time has not been entered for the program
to which the valve is assigned.
12.Seasonal Adjust for the valve's program is set to
0%.
13.An electrical surge or lightning strike has
damaged the controller's electronics.
14. MANUAL START / ADVANCE key has been
pressed.
15.An unwanted start time may have been entered.
16.The programs may be stacked.
CORRECTION
See correction for Cause #6.
See correction for Cause #2.
See correction for Cause #5.
Push the RESET BUTTON.
If the electrical surge did no permanent damage, the controller will accept programming
commands and function normally.
To cancel a program that has been manually started, set the dial to
seconds. Then set the dial back to AUTO.
Turn the dial to SET WATERING START TIMES and check to see if any programs
have an unwanted start time. See page 58 for instructions on setting and eliminating
start times.
Programs will stack behind each other if they are scheduled to start while another
program is running. Make sure Programs A, B, and C are not scheduled to start when
any other program is scheduled.
OFF for three
Rain Bird ESP Modular Controller
®