Rain Bird ESP Guía De Instalación, Funcionamiento Y Programación página 60

VI. SET VALVE WATERING RUN TIME
You can set any valve to run from 0 to 6 hours (1-minute increments
for the first hour, 10-minute increments for the remaining.)
1
2
Note: If you turn dial to a valve number with no
installed module, the message "NO 5 - 8", "NO
9 - 10", "NO 11 - 13" appears on the display.
3
Use to adjust run time up or down. If you do not
want the valve to water for the selected
program, set run time to 0. Repeat 2-3 for the
selected program. Repeat 1-3 as needed for
programs B or C.
Rain Bird ESP Modular Controller
®
4
Caution: If all valve run times are
set to 0, the alarm LED will turn on.
VII. SET SEASONAL ADJUST %
This function lets you increase or decrease the run times of all valves
globally by a selected percentage. You can set the % from 0-200%. This
setting will affect ALL programs globally.
1
2
3
Use to adjust time up or down. Default is 100%.
Seasonal adjust % is calculated on the normal
programmed run times for each valve. For
example, if valve 1 is set to run for 10 minutes,
and you set it to 120%, valve 1 will run for 12
minutes.
Installation, Programming and Operation Guide
(Water Budget)
4
Caution: If a value other than
the default 100% is entered, the
will be displayed in AUTO
mode to indicate run time
values are adjusted.
59