Settings On The Roadside Panel(S); Switching Off The Ring Tone On The Monitor(S) - Extel JCH TOUCH SER.R1 Instrucciones De Uso E Instalación

5. USE
a. Settings on the roadside panel(s)
2 settings are accessible in the roadside panel:
- On the upper left side, setting of the sound level for the speaker of the roadside panel.
- On the upper right side, setting of the sound level for the speaker of the monitor.
To change the settings, use a small screwdriver and turn it carefully without force to the
abutments.
b. Settings on the monitor(s)
2 settings are accessible on the right side of the monitor:
c. On the monitor(s) you can choose among 4 ring tones:
You should perform the same operation on the additional monitor.
d. Switching off the ring tone on the monitor(s)
to him by pressing the key
You should perform the same operation on the additional monitor if you also want to hear
the same ring tone.
e. Operation
If needed, remove the protective film from the screen and the camera lens
the face of the visitor is displayed for approximately 40 seconds.
A single press on the
.
key is enough to communicate with the roadside panel.
(Rings only outside)
10GB