Switching On And Off; Working With The Electric Hedge Trimmer - FLORABEST FHL 900 E5 Manual De Instrucciones Original

Switching On and Off

Ensure that you are standing in a
firm position with both hands grip-
ping the hedge trimmer away from
the body. Ensure that the trimmer
is in contact with no other objects
before switching on.
1. Form a loop in the end of the extension
cable and hook this into strain
A
relief ( 19) on the end of the equip-
ment housing.
2. Connect the device to the mains voltage.
3. To switch on, hold the safety
A
switch ( 16) depressed and simulta-
neously press the on/off
A
switch ( 17). The hedge trimmer will
be run at maximum speed. You can re-
lease the safety switch (
4. The equipment will switch off again when
you release on/off switch (
Working with the Electric
Hedge Trimmer
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage to
the cutter bar.
• To avoid eye injuries, always wear the
supplied safety goggles while working
with the hedge trimmer (
• Ensure that the barrier bar (leg protec-
tion) ( A 14) is installed before use.
• Always hold the equipment firmly in
both hands, with one hand on the rear
handle and the other on the front han-
dle ( 13). Thumbs and fingers must
A
be firmly around the handles.
16) again.
A
A
17).
23).
A
• Check the shoulder strap (
pleasant position, which makes it ea-
sier for you to hold the hedge trimmer.
• Switch off the equipment immedi-
ately in the event that the blades are
blocked by solid objects, pull out the
power plug then remove the object.
• Always work away from the mains
power outlet. Set the cutting direction
before starting work. Ensure that the
power cable is kept well away from
the working area. Never lay the cable
over the hedge, where it could easily
be caught up in the trimmer blades.
• Avoid overstraining the equipment dur-
ing work.
Pull out the power plug im-
mediately if the cable is dam-
aged, badly twisted or has
been completely cut through.
Putting down the device
• Place the device on the ground with
the motor housing first.
• The safety cutter bar (
placed on the ground without being
subjected to any pressure.
• Do not apply any static pressure
whatsoever to the cutter bar (
GB
IE
A 20) on a
A 1) must be
1).
A
31