Start-Up; Measuring Length - Powerfix Profi HG03064A Instrucciones De Utilización Y De Seguridad

To insert the battery proceed as follows:
 
O pen the battery compartment cover
the back of the product. You can remove the
used battery more easily with the aid of the
material strip, which is inside the battery
compartment
 
R emove the battery clip from the battery
 
P lug the contacts of the 9 V-blockbattery on
the contacts of the battery clip. Make sure
you fit the batteries the right way round. This
is specified by the profiled shape of the con-
tacts. Also ensure without fail that the material
strip is underneath the battery.
 
I nsert the battery in the battery compartment
and close the cover again, so that it audibly
latches into place.

Start-up



Measuring length


 
P ress the ON/OFF button
product on. If you do not press any button for
60 s, the display
 
T o switch the product off manually, hold the
ON/OFF button pressed down for 3 seconds,
until the display goes out and a double tone
signal sounds.
 
P ress the MODE button
the display shows the symbol for length meas-
urement "
tion 0.00 m (or 0'00").
 
H old the reference area
the start point of your measurement. Hold the
product in such a way, that the reference
28 GB/IE
. Just pull on the material strip.
14
shuts down.
10
8
" as well as the length designa-
to switch the
9
repeatedly, until
of the product at
6
on
13