Adding Surface Areas Or Volumes Together - Powerfix Profi HG03064A Instrucciones De Utilización Y De Seguridad

 
A lign the product and press the READ button
again. If the measurement is successful, the
height appears at the top of the display, and
at the bottom appears the volume in the m
unit of measurement (or cu.ft = cubic feet).
 
P ress the MODE button briefly, if a further
volume measurement is required. The figures
in the display are reset, and the product is
ready for a new volume measurement.
Adding surface areas or
 
volumes together
 
M easure a surface area or volume as de-
scribed in the section "Measuring surface
area" or "Measuring volume". The surface
area / volume appears in the bottom line of
the display.
 
P ress the RECALL button
ured result. The symbol M+ appears in the
display and this indicates that the measured
result, which is shown at the bottom of the
display, is saved in the product
 
P ress the MODE button
uct is now ready to measure the next surface
area or volume.
 
M easure the next surface area or volume in
the same way as you performed the first
measurement.
 
N ow press the RECALL button again to adopt
the new result into the aggregate memory.
The result of the addition is shown in the
bottom line of the display.
 
I f you would like to add further surface areas
or volumes, repeat steps 3 to 5.
to save the meas-
5
.
10
briefly. The prod-
8
GB/IE
3
33