Technical Data - Profi Cook PC-ES 1008 Instrucciones De Servicio

Problem Possible cause
Espresso escapes at
the filter holder edge.
The filter holder is not
properly attached or is not
enough closed.
Too much coffee grounds in
the filter insert.
Coffee grounds residues on
the rubber seal of the group
head.
Espresso is too cold. The cups were not pre-
heated.
Indicator lamp
not light up during the brew-
ing process.
Coffee crema is The coffee grounds are too
slightly discoloured coarse or are not evenly
(coffee runs out fast). spread.
Too little coffee grounds in
the filter insert.
Coffee crema is dark The coffee grounds are
discoloured (coffee too fine or compressed too
runs out slowly). much.
Too much coffee grounds in
the filter insert.
No crema on the The espresso grounds are
espresso. not suitable.
The milk does not The milk is not suitable.
froth.
The milk is not cold enough. Use refrigerated milk.
The steam nozzle is dirty.

Technical Data

Model: .................................................. PC-ES 1008
Power supply: ................................... 230 V~, 50 Hz
Power consumption: .................................... 1000 W
Capacity: ......................................................1.5 Liter
Protection class: ...................................................... I
Pressure:.........................................................15 bar
Net weight: .........................................approx. 4.7 kg
64
Solution
Stop the brewing process!
Attach the filter holder properly as instructed under
"Attach / Detach Filter Holder".
Remove excess coffee grounds. Observe the MAX
marking in the filter insert.
Switch the appliance off and let it cool down.
Clean the rubber seal as instructed.
Rinse the cups with hot water.
does Wait until the indicator lamp
Use the supplied tamper.
Fill coffee grounds only to MAX marking in the filter
insert.
Loosen the coffee grounds. Spread it evenly and
only slightly compress with the tamper.
Use less coffee grounds. Observe the MAX marking
in the filter insert.
Change the brand, if necessary.
Use milk with at least 3.5% fat content.
Clean the steam nozzle as instructed.
Subject to technical changes without prior notice!
This device has been tested according to all
relevant current CE guidelines, such as electro-
magnetic compatibility and low voltage directives,
and has been constructed in accordance with the
latest safety regulations.
lights up.