•
PTZ (Pan/Tilt/Zoom) Control
•
With the RS-485 communication connection, MAX. 255 units of cameras can be connected to a single
controller.
•
Pelco-D or Pelco-P protocols can be selected as a control protocol in the current firmware version.
•
OSD (On Screen Display) Menu
•
OSD menu is provided to display the status of camera and to configure the functions interactively.
•
The information such as Camera ID, Pan/Tilt Angle, Direction, Alarm Input and Preset is displayed on
screen.
•
Alarm In/Out Function
•
4 alarm sensor inputs and 2 alarm sensor outputs relays.
•
Alarm sensor input is decoupled with photo-couplers to avoid external electric noise and shock perfectly.
•
Both of N.O.(Normal Open) sensors and N.C.(Normal Close) sensors can be used and the signal range of
the sensor input is from DC 5.0V to 12.0V for various applications.
•
The camera can be set to move to a Preset position or to run functions such as Pattern, Swing and Group
when there are external sensor activations. Also "Post Alarm" function is possible, which is supposed to
activate after user-defined time period and sequentially in succession to the action by external sensor
activations.
•
Reserved Presets (Hot Keys)
•
Most camera setup options can be set up easily and directly with the reserved presets (Hot Keys), without
entering into OSD menu. For more information, refer to "Reserved Presets (Hot Keys)".
Warning
- The installation and calibration of this camera must be carried out by highly skilled personnel.
- Do not open the camera: there may be a risk of electric shock.
- Low voltage cameras must be powered by a power supply unit with stabilized voltage.
This range of cameras has been created for CCTV applications and not for other uses.
Use these cameras only for the following temperature conditions: from (-10) – (+50) °C.
Do not use the cameras with voltages different from the ones specified.
Safety instructions
This product should be installed in line with installation rules, preferably by a qualified electrician. Incorrect installation and use can lead to risk of electric shock or fire.
Before carrying out the installation, read the instructions and take account of the product's specific mounting location.
Do not open up, dismantle, alter or modify the device except where specifically required to do so by the instructions. All Legrand products must be opened and repaired exclusively by personnel trained
and approved by Legrand. Any unauthorised opening or repair completely cancels all liabilities and the rights to replacement and guarantees.
Use only Legrand brand accessories.
22