Descargar Imprimir esta página

DURAVIT D.1e D11100 0070 10 Instrucciones De Montaje página 6

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 12
These instructions are part of the Duravit
product and must be read carefully and kept
available at all times.
Target readership and qualifications
The product may only be installed by a
qualified plumber.
Explanation of the key words and symbols
NOTICE
Addresses practices not related to
physical injury.
Link to the mounting instructions
in this section
Prompt for inspection
(e.g. for scratches)
Prompt to inspect
for leaks and leak-tightness
Prompt to wear
gloves
Indication of the length of time
(e.g. 10 minutes)
Technical data
Operating pressure
Recommended
Test pressure
Pressure difference K/W max. 0.1 MPa
1 MPa = 10 bar = 145 PSI
Hot water temperature
Operating temperature
6
MAL_57325/20.07.3
max. 0.5 MPa
(max. 5 bar)
0.3 MPa
(3 bar)
0.5 MPa
(max. 5 bar)
(max. 1 bar)
max 60 °C
4 – 40 °C
Safety instructions
NOTICE
Cut and crushing injuries
> Wear gloves when installing the product.
Product and/or property damage
> Observe the local installation regulations
and any country-specific standards at all
times.
> Equalise pressure differences between cold
and hot water connections.
> Observe the manufacturer's instructions for
installation with continuous flow heaters.
Mounting instructions
1
Flushing and siliconising (diagram 01)
NOTICE
Tap unit malfunction due to dirty pipes
> Flush the pipes according to the applicable
standards before mounting the tap unit.
Water damage
> Enclose pipes with silicone that does not
contain acetic acid.

Publicidad

loading

Este manual también es adecuado para:

D.1e d11100 0070 46D.1e d11110 0070 10D.1e d11110 0070 46