Operating The Remote Hand Switch; Maintenance - RK Rose+Krieger RkMultiControl Instrucciones De Montaje

6.4 Operating the remote hand switch

•
Press the UP (1) or DOWN (2) key and keep the re-
spective key pressed until the drives have moved to
the desired position.
By pressing the UP (1) or DOWN (2) keys, all drives connec-
ted to the controller are traversed.
If a key is pressed for longer than 40 seconds, the transmis-
sion is interrupted. This prevents an accidental continuous
transmission. The transmission can be continued after letting
the key go for about 3 seconds.
The initialisation mode of a RKMultiControl duo/quadro
can be started (see assembly instructions RKMultiControl
duo/quadro) and the lighting of the FLASH RF receiver can
be switched on and off by pressing the UP and DOWN keys
simultaneously when switching on.

6.5 Maintenance

The remote hand switch is maintenance-free.
You may only work on the remote hand switch in accordance with these instructions. The actions
described in the assembly manual are to be observed. If there is a fault with the unit, we recom-
mend that you contact the manufacturer or send the unit for repair.
6. Life Phases
1
2
29