Fault Solution; Disposal And Return - RK Rose+Krieger RkMultiControl Instrucciones De Montaje

6.7 Fault solution

If an error occurs that is not listed in this table, please contact your supplier / dealer.
Fault
The LED does not light up in the
remote hand switch
RF receiver does not react
No function despite
programming
Several RF receivers react simulta-
neously

6.8 Disposal and return

The hand switch must either be disposed of in accordance with the applicable regulations and
guidelines, or returned to the manufacturer.
The hand switch contains electronic components, cables, metals, plastics etc. and is to be dis-
posed of in accordance with the applicable environmental regulations of the respective country.
In Germany, disposal is governed by the Elektro-G (RoHS) [Electrical Code], and in the European
region by EU Directive 2011/65/EC or the relevant national legislation.
Do not dispose of in domestic waste.
•
Check the poles of the batteries
•
Change the battery
•
Check the mains voltage of the controller / Powerlift
and, where applicable, restore it
•
Log the remote hand switch onto the RF receiver
again
•
Reduce the distance to the drive system (RF receiver)
•
Make sure that no other remote hand switch is ac-
tuated at the same time, e.g., garage door opener
or car key
•
Log the remote hand switch onto the RF receiver
again
•
Check the mains voltage of the drive and, where
applicable, restore it
•
Repeat the login process
•
Please contact your dealer.
•
Log the remote hand switch onto the RF receiver
again
6. Life Phases
Remedy
31