Operation; Tailstock Adjustment; Tool Rest Adjustment; On-Off-Switch - Holzmann D 300F Manual De Instrucciones

Torno de madera
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
15.2

Operation

15.2.1 Tailstock adjustment

Move the tailstock (5) by loosening the lock lever (1)
and pushing the tailstock to the desired position on the
bed. Lock by tightening the lock lever (1).
The spindle can extend up to 2 1/2" from the tailstock
housing. You can move the tailstock spindle (4) by
loosening the spindle lock lever (2) and then turning
the hand wheel (3). Turning the hand wheel clockwise
extends the spindle; turning it counterclockwise
retracts the spindle. Lock the lock levers (1) and the
spindle lock levers (2) before operating the lathe.
The tailstock spindle is hollow and can be accessed
from the handwheel end. Use the push-out rod to
remove the center cup or to drill holes through the
center of a workpiece on a faceplate.

15.2.2 Tool rest adjustment

To move the tool rest base (1), loosen the lock lever
(4) and move the base to the right or left and back or
front. Tighten the lever (4) when the tool rest base is
in the desired position.
To adjust the angle of the tool rest (2), loosen the
lock lever (3), move the tool rest to the desired
position, and tighten the lock lever.
To change to the other tool rest, loosen the lock lever
(3) and pull the tool rest (2) out of the tool rest base,
insert the other tool rest, adjust to desired position,
and tighten the lock lever (3).
 The tool rest should be selected as close as possible to the
workpiece!
 Height adjustment just below the centerline of the workpiece.
 Rotate the workpiece by hand and check that the workpiece can
rotate freely before turning!

15.2.3 On-Off-switch

Switch on: Push the green button ("I") for 2 seconds. The machine begins to
run.
Observe the circuit breaker reset button (2).
Switch off: Push the red button ("0").
The machine does not stop immediately! Stay as long at the machine, until
the workpiece is completely stopped (Do not stop the workpiece by hand!)

15.2.1 Speed adjustment

The speed of the D300F is infinitely variable with the speed controller (3) in a
range of 750 – 3200min
HOLZMANN MASCHINEN GmbH
-1
after switch on (1) adjustable.
www.holzmann-maschinen.at
N O T I C E
OPERATION
29
D 300F

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido