Install Access Panel - Whirlpool WDT750SAHZ Manual De Uso

INSTALL ACCESS PANEL

– For Plastic: Begin with Step 62
– For Metal: Begin with Step 65
Plastic Panel:
62.
Reinstall access panel and fasteners
Insulation
(on some models)
Place the plastic access panel against the dishwasher leg.
Make sure insulation does not interfere with the float assembly.
63.
Check access panel edge
Check that the lower edge of the access panel touches the
floor. Adjust if necessary.
64.
Tighten fasteners
1/4
turn
Using a flat-blade screwdriver, turn the fasteners
clockwise to lock into place. The fastener slot will be straight
up and down when properly locked. Go to Step 68.
Metal Panel:
65.
Place the panel against dishwasher legs. Using a Phillips
screwdriver or
the holes in the access panel.
66.
Check that the lower edge of the access panel touches the
floor. Adjust if necessary.
67.
Tighten access panel screws.
/ turn
1
4
Reinstall access panel
/ " nut driver, reinstall the screws through
1
4
Check lower panel edge
Tighten screws
25