Pre-Alarm; Information Screen - Tripp-Lite SmartOnline 208V SV Serie Manual De Uso

9. Control Panel
Battery Capacity in Ah
Maximum Charging Current
Battery Low Voltage
Battery Low Capacity
Battery Shutdown Voltage
Periodic Battery Test
Battery Test Interval
Stop by Time
Stop by Battery Voltage
Stop by Battery Capacity
Battery Age Alert
Temperature Compensation

9.3.6.4 Pre-Alarm

The SETUP – PRE-ALARM screen may be accessed in any UPS operating mode. All settings may be made in any operating mode.
Line Frequency Range
PRE-ALARM

9.3.7 Information Screen

Use Down/Right key to select "INFORMATION" option. Press "Enter" key to enter Information sub-menu.
The Information screens offer an overview of all the programmed UPS system states. A summary is provided below.
Identification
Data
Model Name
Serial Number
Display#ID Firmware Version
STS# xx Firmware Version
Module#ID DSP Firmware Version
Module#ID MCU Firmware Version
Module#ID Serial Number
Note: Module information may repeat depending on number of power modules installed.
SmartOnline SV-Series UPS Operating Mode
Standby Bypass
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Line Voltage Range
Load
HOME MENU
Line Battery
Y
Y
Y
Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Table 9.5
Set line voltage range. Upper limit: +5/10/15/20%; lower limit: -5/10/15/20%
(Default: +15/-20%)
Set line frequency range. Upper limit: +1/2/3/4 Hz; lower limit: -1/2/3/4 Hz
(Default: +/-4%)
OVERLOAD: Set UPS overload (40-100%) (Default: 100%)
LOAD UNBALANCE: Set output load unbalance (20-100%)
INFORMATION
User Adjustable / Section Reference
No
No
No
No
No
No
No
26
Battery Test Fault
Y
Y
Y
Y
Y Y
Y Y
Y
Y
Y
Y Y
Y Y
Identification
System
Battery
Converter ECO
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y