Troubleshooting Guide - LG LFD22786 Serie Manual De Usuario

8. FLUSH OUT THE TUBING
Turn the main water supply on and
flush out the tubing until the water
is clear.
Shut the water off at the water
valve after about one quart of
water has been flushed through the
tubing.
9. CONNECT THE TUBING TO THE
REFRIGERATOR
NOTE: Before making the connection to the
refrigerator, be sure that the refrigerator power cord is
not plugged into the wall outlet.
a. Remove the plastic flexible cap from the water valve.
b. Place the compression nut and ferrule (sleeve) onto
the end of the tubing as shown.
c. Insert the end of the copper tubing into the
connection as far as possible. While holding the tubing,
tighten the fitting.
Tubing Clamp
¼ in.
Compression
Nut
Ferrule
(sleeve)
WARNING: Never use old or used hoses. Always
use new ones to have a better use and experience.
Connect always to a potable water source to avoid
security and health issues.

TROUBLESHOOTING GUIDE

10. TURN THE WATER ON AT THE SHUTOFF VALVE
11. PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the wall.
Push the refrigerator back to the wall.
¼ in. Tubing
Refrigerator
Connection
12. START THE ICEMAKER
Set the icemaker power switch to the ON position.
The icemaker will not begin to operate until it reaches
its operating temperature of 15°F (–9°C) or below. It
will then begin operation automatically if the icemaker
power switch is in the ON (I) position.
29
Tighten any connections that leak.
CAUTION: Check to see if leaks occur at the water
line connections.