Steps For Installation; Installing Your Washer - Haier XQG50-11 Manual Del Usuario

[eveMing Your Appliance
• Your washer has 4 leveling legs; which are located on the four bottom corners.
After properly placing your washer in its final position, you can level your washer.
• Leveling legs can be adjusted by turning them
counterclockwise to raise your washer or turning
them counter clockwise to lower your washer,
Steps for Installation
Select a suitable location for this appliance on a hard even surface away from
direct sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances
etc, Any floor unevenness should be corrected with the leveling legs located
underneath, on the bottom corners. This appliance must be placed at room
temperature. You must not place this appliance where the temperature is at below
freezing,
Installing Your Washer:
Read install instructions carefully before installation,
Caution: If, after completing these steps, you are unsure that unit is properly
installed, contact a qualified installer. To ensure that your appliance is
properly installed it is recommended that it be installed by a certified
installer,
1. Insert a new flat washer into each end of the inlet hoses. Firmly put the washers
in the coupling,
Note: You may have to use pliers to tighten the coupling. Do not over tighten
because you may cause damage to the valve,
23