Steps For Installation - Haier XQG65-11SU Manual Del Usuario

XQG65-11SU -MANUAL 10/29/02 1:50 PM F/_ 25
[eveMing Your
Appliance
• Your washer has 4 leveling legs; which are located on the four bottom corners.
After properly placing your washer in its final position, you can level your washer,
• Leveling legs can be adjusted by turning them
counterclockwise to raise your washer or turning
them counter clockwise to lower your washer,
Steps for Installation
Select a suitable location for this appliance on a hard even surface away from
direct sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances
etc. Any floor unevenness should be corrected with the leveling legs located under-
neath, on the bottom corners. This appliance must be placed at room temperature.
You must not place this appliance where the temperature is at below freezing.
Installing Your Washer:
Read install instructions carefully before installation,
Caution: If, after completing these steps, you are unsure that unit is properly
installed, contact a qualified installer, To ensure that your appliance is
properly installed it is recommended that it be installed by a certified
installer,
1. Insert a new flat washer into each end of the inlet hoses. Firmly put the washers
in the coupling,
Note: You may have to use pliers to tighten the coupling. Do not over tighten
because you may cause damage to the valve,
23