Custom Program; Steam Functions - LG DLEX8100 Serie Manual De Propietario

Ocultar thumbs Ver también para DLEX8100 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Custom program

If you have a special combination of settings that you
use frequently, you can save these settings as a custom
program.
* to save a custom program:
1. Turn on the dryer and turn the cycle selector knob to
select the desired cycle.
2. Use the cycle setting buttons to adjust the settings for
that cycle.
3. Press the cycle option button(s) for the option you
would like to add. A confirmation message will be
shown in the display.
4. Press and hold the Custom Program button for 3
seconds.
NOTE
You may save only one custom program at a time.
Pressing and holding the Custom Program button will
overwrite any previously saved custom program.
to recall a custom program:
1. Turn on the dryer.
2. Press the Custom Program button to select the saved
cycle.
3. Press the Start/Pause button to start the cycle.

Steam functions

to Fill the Steam Feeder
1. Pull out the drawer.
2. Lift out the steam feeder.
MFL67731082_en_170712.indd 37
3. Fill the steam feeder just to the filter screen.
Water
ONLY
Steam
Feeder
4. Place the steam feeder in the drawer; then push in the
drawer until it clicks into place.
NOTE
Before using a Steam Cycle, the steam feeder must be
filled with water up to the MAX line. If not, the
will be displayed. Make sure that the steam
feeder is filled with water or the drawer is fully closed.
Turn the dryer off then restart the steam cycle.
• Only use water. Do not fill the steam feeder with
foreign substances, rinse agents, or detergents.
Drawer
• Before moving the dryer, make sure the steam feeder
is empty.
• Do not use distilled water; the water level sensor in
the steam generator will not work.
• Be careful to put the Steam Feeder otherwise water
will be overflow.
• Wipe up any spilled water around the Steam Feeder
and the drawer before starting the dryer.
• Do not fill the steam feeder with hot water (over
86°F/30°C).
wWARNINg
• Do not fill the steam feeder with liquids such as
gasoline, dry-cleaning solvents, or other flammable
or explosive substances. Failure to follow this warning
can cause serious injury or death.
• Do not drink water from the steam feeder. Failure to
follow this warning can cause serious injury or death.
37
HOW TO USE
2017.7.12 5:11:52 PM

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Dlgx8101 serieDlgx8101v

Tabla de contenido