Step 7: Slide Dishwasher Into Cabinet; Step 8: Level Dishwasher - LG LDS5040ST/00 Manual De Instrucciones

10
INSTALLATION INSTRUCTIONS

STEP 7: SLIDE DISHWASHER INTO CABINET

y Before sliding the unit into place you will need to at-
tach the mounting brackets. See page 11 for mount-
ing bracket instructions.
y Before sliding the dishwasher into place, raise the
dishwasher by adjusting the front and rear legs of the
dishwasher to the approximate height of the opening.
Although you will need to make fine tune adjustments
after it is in place, this method will minimize those ad-
justments.
y Slide the dishwasher carefully into the cabinet open-
ing.
y Make sure the drain hose inside the cabinet is not
kinked or pinched.
y Make sure the water supply line and electrical supply
are routed through the channels under the dishwash-
er as shown in Fig. 11.
y To avoid kinked or pinched drain hose, be sure to pull
on the drain hose while you slide the dishwasher into
place, not allowing any slack behind the dishwasher.

STEP 8: LEVEL DISHWASHER

1. Make sure that the
dishwasher is level.
Place level on the
top front opening
of the tub from
side to side.
3. Make sure that
the dishwasher is
plumb. Place level
on the front side
of the cabinet.
FIG. 11
Drain Hose
Water supply
line
2. Make sure that the
gap between the
door and the tub
is equal on both
the left and right
sides.
Electrical
Cable
Water Supply Tube
Front of
dishwasher
Electrical
Supply