Step 2: Prepare Electrical Wiring - LG LDS5040ST/00 Manual De Instrucciones

These installation instructions are intended for use by Qualified Installers.
WARNING
For personal safety, remove house fuse or open circuit breaker before installation.
Do not use an extension cord or adapter plug with this dishwasher. Electrical and grounding connections
must comply with the National Electrical Code/provincial and municipal code and/or other local codes.

STEP 2: PREPARE ELECTRICAL WIRING

1. This appliance must be operated with correct voltage as shown in this manual and on the rating plate, and con-
nected to a dedicated properly grounded branch circuit, protected by a time-delay fuse. Wiring must be 3 wires
including ground.
2. If an outlet and a three-prong power cord is used, it should be in an accessible location adjacent to and not behind
the dishwasher and within 4 ft. (1.2 m) of the dishwasher side.
3. The wiring or cord must be grounded properly. If in doubt, have it checked by a qualified electrician. Do NOT con-
nect any other appliance to the same outlet.
4. The wiring or cord must be routed as shown in Fig. 4 below.
5. Make sure electrical cable is oriented in the bottom channels as shown in the figure below.
NOTE
If you find any damage to the dishwasher, please contact your dealer or builder immediately.
FIG. 4
INSTALLATION INSTRUCTIONS
Electrical Cable
4 ½" – 6"
(115 mm – 152 mm)
7