Profi Care PC-BMG 3018 Manual De Instrucciones página 166

4. The monitor requires 6 hours to warm from the minimum storage
temperature between uses until the monitor is ready for its in-
tended use when the ambient temperature is 20 °C. The monitor
requires 6 hours to cool from the maximum storage temperature
between uses until the monitor is ready for its intended use when
the ambient temperature is 20 °C.
5. Do not attempt to disassemble this monitor.
6. Not servicing / maintenance while the monitor is in use.
7. If you do not use the monitor for a long time, please remove the
batteries.
8. It is recommended the performance should be checked every
2 years or after repair. Please contact the service centre.
9. Clean the monitor with a dry, soft cloth or a soft cloth squeezed
well after moistened with water, diluted disinfectant alcohol, or
diluted soapsuds.
10. No component in the monitor can be serviced by the user. The
circuit diagrams, component part lists, descriptions, calibration
instructions, or other information which will assist the user's
appropriately qualified technical personnel to repair those parts of
equipment which are designated repairable can be supplied.
11. The monitor can maintain the safety and performance charac-
teristics for a minimum of 10,000 measurements or three years,
and the cuff integrity is maintained after 1,000 open-close cycles
of the closure.
12. It is recommended that the cuff should be disinfected 2 times
every week if needed (for example, in a hospital or in a clinic).
Wipe the inner side (the side that contacts skin) of the cuff with a
soft cloth moistened with ethyl alcohol (75 - 90 %) and squeezed,
then dry the cuff by airing.
166
PC-BMG 3018_IM_new 08.07.19