Device Control - Televes COFDM-PAL NICAM Manual De Instrucciones

User manual

6.- DEVICE CONTROL

The COFDM-PAL NICAM module can be
configured and monitored from a PC, using
both local and remote control, by means the
headend control software v.2.2.0 or upper.
a.- Local control
It is necessary to dispose of the "Headend
Management" program (v.2.2.0 or upper)
and a special cable (provided with this pro-
gram) that connects a serial port from the to
the "PRGM" connector of the COFDM-PAL..
Using the program you can configure and
read all the operation parameters, as well as
monitor the device.
You can check that the configurable para-
meters are the same ones as those modifi-
cad on the remote control. Another advanta-
ge is that you can select the desired pro-
gram using its name.
b.- Remote control
It is necessary to dispose of a Headend
Control module (ref. 5052) that includes the
previously-mentioned program, and the
corresponding modem connected to the
phone line.
Once communication has been established
with the headend control, it will be possible
42
COFDM-PAL NICAM
to access all the controllable devices that
have been installed in the headend.
In this case, it is essential for each element
to be programmed with a unique device
address (RS465 address) using the numbers
between 1 and 254.