Wiring Connection; Important; Remote Control (Rm-Rk52) - JVC KD-R890BT Manual De Instrucciones

INSTALLATION/CONNECTION

Wiring connection

IMPORTANT

We recommend installing the unit with a commercially
available custom wiring harness specific for your car and
leave this job to professionals for your safety. Consult your
car audio dealer.
Vehicle
dashboard
Factory wiring
harness (vehicle)
Custom wiring harness
Blue:
(separately purchased)
To power antenna
Blue/white:
To amplifier
Brown (not used)
Recommended connection
34
ENGLISH
Front output/3-way crossover: Mid range output
Rear/subwoofer output/3-way crossover: Woofer
output
Antenna terminal
Light blue/yellow
To the steering wheel
remote control adapter
Join the same color wires together.
Blue/white: Remote (12 V
Orange/white: Illumination
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker/3-way crossover: Mid range speaker (right)
Gray/black
White: Front speaker/3-way crossover: Mid range speaker (left)
White/black
Purple: Rear speaker/3-way crossover: Tweeter (right)
Purple/black
2
Green: Rear speaker * /3-way crossover: Tweeter (left)
Green/black * 2
Fuse (10 A)
350 mA)
Separate red wire
Make this connection if your vehicle factory wiring
harness does not have "12 V ignition switch" wire.
*
1
Firmly connect the ground wire of the amplifier to the
car's chassis to avoid damaging the unit.
*
2
You can also connect a subwoofer speaker directly using
this lead without an external subwoofer amplifier. For
setting,
Signal cord (not supplied)
JVC Amplifier *
Microphone input jack ( 12)
Remote wire (not supplied)
Ignition switch
Car fuse block
22.
1