Makita HR4001C Manual De Instrucciones página 9

Lubrication
CAUTION:
This servicing should be performed by Makita
•
Authorized or Factory Service Centers only.
This tool requires no hourly or daily lubrication because
it has a grease-packed lubrication system. It should be
relubricated after every 6 months of operation. Send the
complete tool to Makita Authorized or Factory Service
Center for this lubrication service.
006326
Run the tool for several minutes to warm it up. Switch off
and unplug the tool.
Loosen the four screws and remove the handle. Note
that the top screws are different from other screws.
Disconnect the connector by pulling them.
3
006327
Loosen the screws and remove the change lever.
2
006328
Remove the crank cap cover.
Remove the control plate.
1. Screws
1
1. Connector
1
2. Black
3. White
2
1. Change lever
3 2. Screw
3. Crank cap cover
1
006329
Loosen the six screws with a screwdriver and remove
the crank cap. Rest the tool on the table with the bit end
pointing upwards. This will allow the old grease to collect
inside the crank housing.
006330
Wipe out the old grease inside and replace with a fresh
grease (60 g; 2 oz). Use only Makita genuine hammer
grease (optional accessory). Filling with more than the
specified amount of grease (approx. 60 g; 2 oz) can
cause faulty hammering action or tool failure. Fill only
with the specified amount of grease.
006331
Reinstall the crank cap and tighten with the screwdriver.
Connect the connector and reinstall the handle.
1
006332
9
1. Control plate
1
1. Screwdriver
2. Crank cap
1
2
1. Hammer grease
1
1. Connector
2
2. Black
3. White
3