Battery Installation; Blower Tube Assembly; Battery Removal; Important - Snapper SB60V Manual De Instrucciones

BATTERY INSTALLATION

1. Align the battery with the battery opening.
2. Grasp the blower handle firmly.
3. Insert the battery into the battery opening
until the battery release button locks into
place.
4. Push down on the battery until it locks into
place. you should hear a "click" once it is
installed.

BATTERY REMOVAL

1. Press the battery release button. This will
cause the battery to raise out of the tool.
2. Grasp the blower handle firmly. Pull the
battery pack out of the handle.
Battery release button
NOTE: The battery pack fits snugly into the
handle to prevent accidental dislodging. It
may require a strong pull to remove.
IMPORTANT: The battery is not shipped fully
charged. It is recommended that the battery be
fully charged before initial use. With regular
use, the battery pack will take 1 hours or less
to fully charge. It is recommended that the
battery be charged every 3 months when the
blower is not in use.
ASSEMBLY

BLOWER TUBE ASSEMBLY

WARNING:
starting that could cause serious personal
injury, always remove the battery pack from
the tool when assembling parts.
Tube Groove
1. Align either of the grooves on the tube with
the tabs on the blower housing. Slide the tube
onto the blower housing until the tab engages
the grooves.
Unlock
2. Turn the tube in the direction of the arrow
until both of the tabs slide into the lock
positions.
8
To prevent accidental
Tab
Lock
Lock position