Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operating
SHE6AP
the Dishwasher
On/ Off
®
Half Load
C_
Sanitized
/{llllllll_
Power
Auto
Regular
Delicate
Scrub
Wash
Wash
Wash
iiiiiiiEi//
/iiiiiEi/_i/
Program Select
BOSCH
Refill RinseAgent
r T T_j)
EcoSense
QuiCkwash & RinSeHold 1
Delay
_
Start
To start the dishwasher:
•
Door must be closed. Press the"ON/OFF"
button.
•
The Countdown
Display and one of the Wash Cycle
LEDs will be flashing.
You can now select a wash
cycle.
•
Press the "<" or ">" button to select the desired wash
cycle.
•
Select the "Half Load" or "Delay Start" features
if
desired at this point.
In addition to your Wash Cycle selection, for small loads of
lightly soiled dishes press the "Half Load" button. This will
save energy and water.
If you would like to delay the start time of the dishwasher
press the "DELAY" button
until the
desired delay time
(1-24 hrs.) shows in the Countdown
Display window.
•
Press the "START" button
to begin the cycle (Wash
Cycle Indicator Light will stop flashing)
•
Close the door to begin the cycle
NOTE: Rinse Agent Indicator
Light will be illuminated
if
the unit needs Rinse Agent.
To cancel a cycle:
•
Press and hold the "START/RESET" button
until the
countdown
display reads "0:01 ".
•
Wait until the display reads "0:00" and turn the unit
OFF.
•
Open the door and press the"ON/OFF"
button.
•
You are now ready to start a new cycle.
To enter
the options
mode(rinse
agent
setting,
extra
dry heat, cycle completion
signal):
•
Door must be closed. Press the "ON/OFF" button
to
turn the unit on.
•
The countdown
display and one of the Wash Cycle
LEDs will be flashing.
•
Press and hold down the ">" button, then press and
release the "START/RESET" button.
Now release the
">" button.
•
The "Sanitized"
LED will be flashing. You are now in
the options setup mode.
•
Press ">" to select the
option
you would
like to
adjust.
If the display shows "d:O0" or "d:01" you can turn the Extra
Dry Heat ON or OFF.
If the display shows between "r:O0" to "r:06" you can adjust
the amount of rinse agent dispensed.
To set the amount
of Rinse Agent:
NOTE: If your glasses have spots on them, you need more
rinse agent. If your glasses have streaks, you need less
Rinse Agent.
Follow the prior instructions
to enter "options"
mode.
With the display window
showing "r:O0" - "r:06":
•
Press the "<" button
to change the amount
of rinse
agent dispensed.
r:00--> Rinse Agent OFF
r:03 --> Medium amount
of rinse agent dispensed
nOd --> Highest amount
of rinse agent dispensed
•
Press STARTto save your settings.
To turn Extra Dry Heat on or off:
With the countdown
display showing "d:O0" or "d:01 ":
•
Press the "<" button to turn Extra Dry Heat on or off. 0
d:00 --> Extra Dry Heat is OFF
d:O1 --> Extra Dry Heat is ON
.
Press START to save your settings.
20
Publicidad
Capítulos
Tabla de contenido
