Dry Ironing; Steam Ironing - Oster GCSTCS-401 Manual De Instrucciones

To Fill the Water Reservoir (use tap water)
1. Make sure the iron is unplugged. Set the Steam Lever to
2. Lift the Water Fill Hole Cover.
3. Fill an easy-pour measuring cup with tap water. Pour water into water reservoir.
WARNING: To prevent the risk of burns, be careful when filling a hot iron with water. Hot
metal parts, hot water and steam can cause injuries.
1. Make sure the Steam Lever is turned to the
2. Plug the cord into a 127 or 220-Volt outlet depending on model (see last page for
details).
3. Turn the Fabric Select Dial to select desired Fabric Setting. Allow the iron to heat
until wait/ready light turns from red (wait) to green (ready), indicating the unit is ready.
While the iron is heating, make sure it is sitting on its heel rest on a stable, protected
surface.
NOTE: While the Steam Lever is turned to the
SHOT OF STEAM or SPRAY MIST feature, as long as the fabric setting is set to wool,
cotton, or linen. Please make sure the water reservoir is approximately ¼ full of water.
1. Follow the instructions for "Filling the Water Reservoir."
2. Plug the cord into a 127 or 220-Volt outlet depending on model (see last page for
details).
3. Turn the Fabric Select Dial to select desired fabric setting. Allow the iron to heat until
wait/ready light turns from red (wait) to green (ready), indicating the unit is ready.
While the iron is heating, make sure it is sitting on its heel rest on a stable, protected
surface.
IMPORTANT: When not ironing, always set the Steam Lever to
Select Dial to OFF.
Using the Iron's Special Features
Spray Mist Feature is a powerful water spray mist that dampens the fabric to aid in
removing wrinkles from heavy fabrics and for setting creases.
To use the Spray Mist Feature: Press Spray Mist trigger firmly.
Shot of Steam Feature provides an extra burst of steam for deep penetration of
stubborn wrinkles. You can use this feature while Dry or Steam ironing, as long as the
fabric setting is set to wool, cotton, or linen. The water reservoir must be approximately
¼ full of water.
To use the Shot of Steam Feature: Place the iron on top of the wrinkle and press the
Shot of Steam button each time you would like an extra burst of steam. The Shot of
Steam feature may be used continuously in approximately 3-second intervals.
Vertical Steam allows your iron to function as a garment steamer.

Dry Ironing

(Dry) setting.
(Dry) setting, you may still use the

Steam Ironing

English - 3
(Dry).
(Dry) and the Fabric