Dry Ironing; Steam Ironing - Oster GCSTCC3000 Manual De Instrucciones

1. Ensure Steam Lever is moved to the Dry
the Heating Base on a flat, stable surface (follow instructions for "Corded Ironing").
2. Set Fabric Select Dial according to fabric type (Figure 1).
NOTE: If not sure of the fabric type, it is best to first test the temperature of the iron on a
hem or an inside seam.
3. Plug the solid cord into a 127 or 220-Volt outlet depending on model (see last page for
details).
• The red Indicator Light comes on to indicate iron is heating up.
• When the Indicator Light turns solid green, the iron has reached required temperature
and is ready for use.
4. To use the iron without the cord, follow instructions for "Cordless Ironing."
NOTE: While the Steam Lever is turned to the Dry
OF STEAM or SPRAY MIST feature, as long as the Fabric Select Dial is set to wool,
cotton, or linen / high temperature. Make sure the water reservoir is approximately ¼ full
of water.
1. Follow the instructions for "Filling Water Reservoir" and "Corded Ironing."
2. Move Steam Lever to desired steam setting. Set Fabric Select Dial according to fabric
type (refer to Figure 1).
NOTE: If not sure of the fabric type, it is best to first test the temperature of the iron on a
hem or an inside seam.
3. Plug the cord into a 127 or 220-Volt outlet depending on model (see last page for
details).
• The red Indicator Light comes on to indicate iron is heating up.
• When the Indicator Light turns solid green; the iron has reached required temperature
and is ready for use.
4. To use the iron without the cord, follow instructions for "Cordless Ironing."

Dry Ironing

setting and iron is locked in position on
Figure 1
setting, you may still use the SHOT

Steam Ironing

English - 4