Dry Ironing; Steam Ironing - Oster GCSTCM2001 Manual De Instrucciones

For Steam Iron Model GCSTCM2003:
1. The blue LED temperature display will turn on and it will remain on for as long as
the iron is plugged in.
2. Select the desired temperature using the digital temperature control up and down
buttons.
3. The blue LED temperature display light will indicate the selected temperature
setting and will stay solid on. Once the iron reaches the selected temperature the
light at the temperature display will start blinking. The light will go from solid on
to blinking and back to solid on from time to time while you are ironing since the
thermostat automatically maintains the soleplate at the same temperature.
Another important feature of your steam iron is the 360º swivel cord, which prevents
tangling and allows for easy use by both right and left handed people.

DRY IRONING

1. Insert the plug in the electrical wall outlet.
2. Make sure the steam select switch is in the closed position.
3. Select the desired temperature on the temperature control dial (Models
GCSTCM2001 & GCSTCM2002)/digital temperature up and down buttons
(Model GCSTCM2003).
4. Follow instructions from section "Using Steam Your Iron" for your iron model.
5. Start dry ironing.

STEAM IRONING

Choosing the Right Water
This steam iron may be used with normal tap water. However, if the water of the
region in which you live is especially hard, it is recommended to use distilled water to
prolong the life of your iron.
Do not use water that has been desalinated with chemicals.
Filling with Water
1. Turn off the iron and disconnect the plug from the
electrical wall outlet before filling the iron with water.
2. Turn the steam select switch to the closed position.
3. Set iron in the position indicated below (figure 2) and fill
it with water, no higher than the Max fill level shown on
see-through water window.
En g lish -5
Figure 2