Panamax MB1000 Manual De Instrucciones página 6

Basic Operation FRONT PANEL DESCRIPTION
IR Detector
Power Switch
IR Detector, for
Press and hold the power
sampling IR
button for 2 seconds to turn
remote control
the UPS ON or OFF.
signals.
BANKS WIRING
1 2
FAULT
POWER
Outlet Bank 2 Indicator
Outlet Bank 1 Indicator
Illuminated blue when outlet
Illuminated blue when outlet
bank 2 is switched on.
bank 1 is switched on.
Ground Lug
BANK 2
NON CRITICAL
LOAD
Outlet Bank 2 - Non-Critical-
Load Outlets
Four battery powered, surge
protected and AVR outlets for
connected equipment insures
temporary uninterrupted op-
eration of connected equipment
during a power failure. These
outlets will shut off when the
batteries drain to a designated
level to reserve remaining bat-
tery charge from the critical load
outlets.
Menu Navigation Knob
Rotate clockwise to navigate
to the next screen, counter-
clockwise to return to the
previous screen, push to
select menu item.
MENU
Line Fault Indicator
This LED will illuminate in red to warn the user that a wiring problem such as a bad/miss-
ing ground or reversed wiring exists within the AC receptacle. If illuminated, disconnect all
equipment and contact an electrician to insure outlet is properly wired.
Circuit Breakers for Overload
Protection
Resettable circuit breakers provide
optimal overload protection.
BANK 1
CRITICAL
LOAD
Outlet Bank 1 - Critical Load
Outlets
Four battery powered, surge protected
and AVR outlets for critical-load equip-
ment insures temporary uninterrupted
operation of connected equipment
during a power failure.
Status Display
LCD displays status and
menu navigation items
AC Power Cord
12 A
IR OUT
MAIN
POWER
120 / 12A
IR Control Section
Indicator LED's – Indicates status
IR Output Jacks – Standard 1/8"
(3.5mm) mono jack for connection
to an IR flasher (IR flashers not
included)
3
Removable Battery
Access Panel
Easy to remove for
battery access and
replacement.
USB to Computer
IR1
IR STATUS
IR2
RS-232
RS-232
Serial Communication Port
The serial port allows connection and communica-
tion between the UPS and an automation or com-
puter system. This allows the installer to program
a number of variables including the Critical Load
Battery Threshold. See the software documentation
for more information.
MB1000