HQ-Power VDP150MH6N Manual Del Usuario página 6

The control board allows you to assign the DMX address, which is defined as the first channel from which the device
will respond to the controller. Make sure not to overlap channels in order to control each VDP150MH6N correctly and
independently from any other fixture in the DMX chain. If you address two, three or more fixtures similarly, they will
work similarly. For addressing, press the MODE button until the display shows "d". Set the desired address via the
UP and DOWN buttons.
After having addressed all the fixtures, you can start operating them via your lighting controller.
NOTES:
After switching on the fixture, the VDP150MH6N will automatically detect whether DMX512 data is received or not. If
the data is received, the control LED will flash. If there is no data received, the control LED lights permanently. This
situation can occur when:
- the 3-pin XLR plug (the cable with DMX signal form the controller) is not connected with the input of the
VDP150MH6N
- the controller is switched off or defective, when the cable or connector is defective or the signal wires have
been swapped in the input connector
It is necessary to insert the XLR 120 termination plug in the last fixture in the chain in order to ensure proper
transmission on the DMX data link.
c) DMX Values per Channel
Channel N°
1
2
3
4
5
6
VDP150MH6N
Description From
Pan
Tilt
17
34
51
Colour Wheel
68
85
102
119
136
Gobo Rotation
121
140
32
64
Rotating Gobo 96
Wheel
128
160
192
224
Shutter, Dimmer
30
251
To
0 16
33
0
67
84
101
118
135
255 Rainbow effect with increased speed
0 4
5 120 Forwards gobo rotation with increasing
139
255
0 13
63
95
127
159
191
223
255
0 2
3 29 Dimmer control (shutter open)
250 Strobe effect with increasing speed
255
6
Function
Open / white
Pink
Blue
Orange
Green
Violet
Yellow
Red
No rotation
speed
No rotation
Backwards gobo rotation with
increased speed
Open
Gobo 1
Gobo 2
Gobo 3
Gobo 4
Gobo 5
Gobo 6
Gobo 7
Shutter closed
(max. 13 flashes/sec.)
No function (shutter open)
VELLEMAN