Water Drainage - Tectro TD 1010 Instrucciones De Uso

4
50
man_TD1010 ('16).indd 50
PUSH BUTTON FUNCTIONS
A. Power Push Button
B. DOWN Push Button
C. UP Push Button
D. Timer Push Button
OPERATION
1. Press button once to start operation. Press it again to stop operation.
2. Press or button to set the desired humidity level in the room, which can be set
from 30% to 90% at 5% intervals. After a period of working, when environment
humidity is lower than the selected humidity by 2%, compressor will stop and fan
stops working 3 mintues later. When environment humidity is equel to or higher
than the selected humidity by 3%, compressor will restart after the 3-minute
compressor protection time.
3. Press button to start the timer setting. Press the button to program the time
when the unit turns on and turns off. If you want to cancel the timer programming,
press the button to adjust the time at 00, and press the button ,it will be circulate
from 00-01-02......23-24.It is the programmed time to switch the machine. The
programmed time will be cancelled when to switch compressor manually each time.
The programmed time remains unchanged if the machine stops to work due to
water full or during defrosting.

WATER DRAINAGE

When the drainage tank is full, the tank full indicator light will turn on, the operation will
stop automatically and the buzzer will beep 15 times to alert the user, that the water need
to be emptied from the drainage tank.
EMPTYING THE DRAINAGE TANK
1. Lightly press on the sides of the tank with both hands and pull the tank out gently.
Fig. 4
2. Discard the collected water.
Fig. 5
17-05-16 14:58