Stihl BGA 85 Manual De Instrucciones página 11

Warning!
Always switch off the motor before
cleaning or servicing the unit or replac-
ing parts. The blower fan between the
air intake and output openings rotates
whenever the motor is running. In order
to reduce the risk of injury from contact
with the blower fan, never operate your
blower without a properly mounted
blower tube or with a damaged intake
screen.
Warning!
Never insert any foreign object into the
air intake of the machine or into the noz-
zle of the blower. It will damage the
blower fan and may cause serious injury
to the operator or bystanders as a result
of the object or broken parts being
thrown out at high speed.
Do not place the blower on the ground
when operating at high speed, because
small objects such as sand, grass, dust,
etc. may be pulled into the air intake and
damage the fan wheel. It is best to turn
the machine off when putting it on the
ground.
After Finishing Work
Always clean dust and dirt off the power
tool – do not use any grease solvents for
this purpose.
BGA 85
MAINTENANCE, REPAIR AND
STORING
If you make a warranty claim for a
component which has not been
serviced or maintained properly or if
nonapproved replacement parts were
used, STIHL may deny coverage.
Warning!
Use only identical STIHL replacement
parts for maintenance and repair. Use of
non-STIHL parts may cause serious or
fatal injury.
Strictly follow the maintenance and
repair instructions in the appropriate
section of your instruction manual.
Please also refer to the maintenance
chart in the manual.
Always switch off the
motor, move retaining
latch to ƒ and remove
the battery from the
power tool before carry-
ing out any repairs or
maintenance work or
cleaning the power tool.
This avoids the risk of the
motor starting
unintentionally.
Warning!
Do not attempt any maintenance or
repair work not described in your
instruction manual. Have such work per-
formed by your STIHL servicing dealer
only.
Tighten all nuts, bolts and screws after
each use.
Regularly check the electrical contacts
and ensure that the insulation of the
power cord and plug of the charger is in
good condition and shows no sign of
aging (brittleness).
Electrical components, e.g. power cord
of charger, may only be repaired or
replaced by a qualified electrician.
Clean plastic components with a cloth.
Do not use aggressive detergents. They
may damage the plastic.
Do not spray the machine with water or
other liquid.
Do not clean your machine with a
pressure washer. The solid jet of water
may damage parts of the machine.
Keep the battery guides free from
foreign matter – clean as necessary.
Store the power tool in a dry, locked
location with the retaining latch on ƒ,
the battery removed and out of reach of
children.
English
9