General Warnings; Parts Overview - Bresser NATIONAL GEOGRAPHIC AZ MOUNT Instrucciones De Uso

General Warnings

• Risk of blindness — Never use this device to look directly at the sun or in the direct proximity of the sun.
Doing so may result in a risk of blindness.
• Choking hazard — Children should only use the device under adult supervision. Keep packaging mate-
rial, like plastic bags and rubber bands, out of the reach of children, as these materials pose a choking
hazard.
• Risk of fire — Do not place the device, particularly the lenses, in direct sunlight. The concentration of light
could cause a fire.
• Do not disassemble the device. In the event of a defect, please contact your dealer. The dealer will con-
tact the Service Centre and can send the device in to be repaired, if necessary.
• Do not expose the device to high temperatures.
• The device is intended only for private use. Please heed the privacy of other people. Do not use this
device to look into apartments, for example.
Accessories may vary depending on the model.

Parts overview

1. Telescope (telescope tube)
2. Viewfinder or LED viewfinder
3. Adjusting screws for the viewfinder
4. Attaching screws and nuts for the holder
of the viewfinder
5. Objective lens
6. Eyepiece holder (eyepiece connector)
7. Vertical fine adjustment knob (focus knob)
8. Telescope connecting piece
9. Tripod head with holder
10. Locking clips or screw for the tripod legs
How to assemble the telescope
First, check if your telescope is comparable to version 01 or version 02 (pages 4 and 6). Before you get
started with the assembly, you should take some time to decide where you would like to set up your tel-
escope. It is important that you choose a place from which you have an uninhibited view of the sky, where
the floor is hard and even, and where you have enough space around you so that you feel comfortable.
When you've found the ideal spot, you can begin the assembly.
Version 01
Open the locking clips on the tripod legs (10). Then pull the lower parts of the tripod legs (11) downward
as far as they will go. Finally, close the locking clips again (Fig. 1). You can change the height of the tripod
at a later time by making the tripod legs a bit shorter (again, opening the locking clips, adjusting the legs,
closing the clips).
Connect the telescope (1) to the tripod by pushing the telescope connecting piece (8) into the holder on
the tripod head (9) (Fig. 2). Screw the locating screw for the vertical fine adjustment (12) into the holder in
order to firmly connect both parts.
11. Tripod legs (extendable)
12. Locking screw for the vertical fine
adjustment (upward and downward motion)
13. Locking screw for the vertical axis
(for turning to the right and left)
14. Accessories caddy
15. Eyepieces
16. Zenith mirror
17. Moon filter
18. Erecting lens
EN
15