Dometic MaCave A25G Instrucciones De Uso página 30

Setting up and connecting the appliance
 Note the information on the electrical connection, see chapter "Notes on
the electrical connections" on page 30.
 Remove all the inner and outer packaging material before setting up.
 Using the height-adjustable feet, adjust the device until it is level and there
is a distance of 30 mm between the bottom of the device and the floor
(fig. 4, page 4).
7.2 Notes on the electrical connections
A
NOTICE!
Leave the appliance to stand upright for about 2 hours after trans-
porting, before you connect it to the power supply.
Otherwise this could cause faults in the cooling system.
Observe the following when connecting the appliance:
 Check that the voltage specification on the type plate is the same as that
of the power supply.
 If you use an extension cable, this must be approved for the same values
as the device, see (chapter "Technical data" on page 37).
 Do not use an extension cable or a multiple power socket that can be
switched off with just one switch.
 The cable must rest securely behind the appliance and not be allowed to
lie or hang unprotected. No hot or sharp components may come into con-
tact with the device.
30
MaCave
EN