Steam For Heating Drinks - Bosch TCA 53 Serie Instrucciones De Uso

www.101kofemashina.ru - обзоры, отзывы, характеристики, инструкции, акции и цены
en
Steam for foaming milk
The appliance must be ready for use. You
can foam the milk first and add the coffee
on top, or foam the milk separately and
pour it into the coffee.
¡ ¡
Risk of burns
The nozzle gets very hot. Do not touch the
metal parts.
● Push the sleeve on the nozzle 8 all the
way down.
● Fill the cup approximately 1/3 full of milk.
● Press the steam button
start to flash.
i ¡
The appliance will heat up for approx.
20 seconds.
● Immerse the nozzle 8 deep into the milk,
but do not let it touch the bottom of the
cup.
● As soon as the LED
rotary button 6 to
¡ ¡
Risk of scalding
When the dial 6 is set to
8 may sputter. Escaping steam is very hot
and may cause liquids to sputter. Do not
touch the nozzle 8 or point it at anyone.
● Rotate the cup slowly until the milk is fully
foamed.
● End the process by turning the dial 6
back to "O".
i ¡
To foam more milk, press the steam
h
button again and repeat the whole
process.
Note: When the nozzle 8 has cooled down,
clean immediately. Dried residue is difficult
to remove.
Tip: If possible, use cold low­fat (1,5 % fat)
milk.
www.101kofemashina.ru помогает выбирать кофейную технику с 2010 г.
h
. The LED will
J
lights up, turn the
g h
/ .
g h
/ , the nozzle
Steam for heating drinks
¡ ¡
Risk of burns
The nozzle gets very hot. Do not touch the
metal parts.
The appliance must be ready for use.
● Push the sleeve on the nozzle 8 all the
way up.
● Press the steam button
start to flash.
i ¡
The appliance will now heat up for
approx. 20 seconds.
● Immerse the nozzle 8 deep into the liquid
you want to heat.
● As soon as the LED
rotary button 6 to
¡ ¡
Risk of scalding
When the dial 6 is set to
8 may sputter a little. Escaping steam is
very hot and may cause liquid to sputter. Do
not touch the nozzle 8 or point it at anyone.
● End the process by turning the dial 6
back to "O".
i ¡
To generate more steam, press the steam
h
button again and repeat the whole
process.
Note: When the nozzle 8 has cooled down,
clean immediately. Dried residue is difficult
to remove.
h
. The LED will
J
lights up, turn the
g h
/ .
g h
/ , the nozzle
TCA53 03/2012
17