Precautionary Measures; Transport; Packaging; Inspection On Receipt - Rancilio MILLENNIUM SDE Uso Y Manutención

touch the machine when his hands or feet are wet
or damp;
use the machine when there are children in its
proximity;
allow the machine to be used by children or unfit
people;
obstruct the suction or dispersal grilles with cloth
or any other thing;
do not use the machine when wet or very damp.

4.1. precautionary measures

This machine may only be used with foodstuffs. It
cannot be used for heating liquids or grinding any
other kind of product that could damage and pollute
it.
The manufacturer cannot be held responsible
for damage to people or things caused by
unsuitable, erroneous or irrational use.

5. TRANSPORT

5.1. Packaging

The machine is delivered in a strong cardboard box
with internal protection.
The packaging bears symbols which must be
observed during handling and stocking of the item.
Always keep the package in a vertical position
during transport. Do not turn it over or lay it
on its side and avoid bumping and exposure
to atmospheric agents.

5.2. Inspection on receipt

Check that the machine received corresponds to the
one indicated on the delivery note, including any
accessories.
Check that it has not been damaged during transport
and, if so, inform the forwarder and our customer
service office immediately.
The packing elements (plastic bags,
expanded polystyrene, nails, cardboard, etc.)
must not be left within reach of children as
they are potential sources of danger. Do not
dispose of the packing elements in the
environment; consign them to firms
authorized for their disposal.
60

6. INSTALLATION

The machines are fitted with height adjustable feet.
The surface must be well levelled, dry, smooth,
strong, stable and at a height of approximately 110
cm from the floor.
It does not need to be anchored to the surface and it
does not require any technical operations to dampen
vibrations in order to operate properly.
It is recommended to leave the area around the
machine free to facilitate its use and the performan-
ce of any maintenance operations.
If the machine is wet or very damp, wait until it is
completely dry before installing or using it. It is always
necessary to request an accurate control to qualified
service people in order to find any possible damage
to the electric components.
Reserve an area near the machine for the installation
of the coffee grinding and dosage machine (see
relevant documentation).
The machine is usually equipped with a water
softener, type DP2 or DP4, which must be connected
by the user in compliance with the laws in force.
Should a different softener be installed, refer to the
documentation of the relevant product.
A dreg drawer should be fitted by the installer.
6.1. Connections to be made by the
user.
Hook-up must be carried out by qualified
personnel in full accordance with federal,
state and local regulations.
6.1.1. Water and gas supply (Fig.6)
Connections must be installed close to the machine.
Water drainage pipe 1, having a minimum internal
diameter of 30 mm, equipped with a water-trap
accessible for inspection.
Water supply pipe 2, with a 3/8"G cut-off tap.
Gas supply pipe 3, with a cutoff tap.
The machine with gas heating must be
installed in compliance with current local
laws.