Setting Feed System - Martin Yale 1217A Instrucciones De Operación

NOTE: A continuous run can only be done with single sheets, or properly stapled
sets.
1. Lower the red wheel in the feed table until there is light between it and the black
one.
2. Turn unit on. Hold piece of stock to be ran in between wheels. Slowly raise red
wheel until sheet is pulled in.
3. Power down and set three pieces of stock to be tested in feed tray. Turn unit
back on, it should take them one at a time. If the sheets do not feed at all, the
red wheel is too high, if it tries to take more than one, the wheel is too low.
Readjust as necessary.
To properly load the machine, the stack of paper should be put in the machine in a
reverse – fan. This means that the top sheet should be at the threshold of the black
wheel, and each sheet underneath should be a little further back. This will allow the
machine to pull off the top of the stack in a continuous fashion. It does not need to be
extreme. A _" stack should be fanned out _" from left to right (see photo).
Once the stock is placed into the machine, it will have a slight tendency to slide back
together. Do not attempt to prevent this, it should not be a factor. The paper guides
should not pinch the paper, there should be 1/32" clearance on each side.
Properly Fanned Paper
SETTING THE FEED SYSTEM
PROPER LOADING OF PAPER
Feed Roller
Threshold
Martin Yale Industries, Inc.
251 Wedcor Avenue
Wabash, IN 46992
Info@martinyale com
Retarder
V