Stacking Wheel Adjustment; Maintenance - Martin Yale 1217A Instrucciones De Operación

this would be to lower the red wheel completely and hand feed the sets individually
(unstapled).
The stacking wheel length can be adjusted by sliding the wheels to the appropriate
location (see photo). They are also spring loaded and removable.
When setting the stacking wheels, set them so that exiting force of the fold rollers will
force the leading edge of the folded document under the stacking wheels. If the
document lands on the conveyors completely before starting under the stacking wheels,
it will not work correctly. An example would be; the folded document comes out of the
machine 3 2/3" wide, the stacking wheels should be around 3 _" from the exit of the unit.
Some experimentation may be necessary. When the wheels are properly adjusted,
they will allow the document to exit the machine in a uniform manner.
LUBRICATON
For each 20 hours of machine operation, lubricate the bushings of the machine with 1
drop of medium grade lubricant.
CLEANING
For each twenty hours of operation, clean the folding rollers of the unit with Rubber
Roller Cleaner. This is typically done with a Scotch-Brite pad and an old cotton cloth.
ROTATION OF RETARDER
From time to time the red wheel on the unit will have to be loosened and rotated to a
new side, and then firmly retightened. This is done periodically due to a flat spot
wearing on the surface of the roller.

STACKING WHEEL ADJUSTMENT

Photo 3

MAINTENANCE

Martin Yale Industries, Inc.
251 Wedcor Avenue
Wabash, IN 46992
Info@martinyale com
Photo 4
VII