Features; Installation Information - Franklin Electric PUMPTEC-PLUS Guía De Instalación Y Funcionamiento

PUMPTEC-PLUS Pump Protection System

Features

■ Over/Underload Protection
■ Over/Under Voltage Protection
■ Rapid Cycle Detection
■ Fault Indicator Lights
■ Run Indicator Light
■ 5 hp Contactor
■ Heavy-Duty Terminal Blocks

Installation Information

WARNING
CAUTION
NOTE: This unit requires calibration before operation. Calibration is described in step 7 of the
installation instructions.
Technical Specifications
Horsepower Rating
Operating Voltage
Operating Frequency
Power Consumption
Operating Termperature Range
Over/Under Voltage Trip
Over/Underload Trip
Rapid Cycle Trip
Trip Response Time
Automatic Restart Time
Over/Under Voltage Retry
Calibration Abort Time
Calibration Memory
Contactor Rating
* 220 Volt, 50 Hz for model #5800060500
** Percent of load time of calibration SNAPSHOT
4
■ Snapshot Calibration
To avoid possible fatal shock, disconnect power at the main power panel
before installing, wiring or servicing Pumptec-Plus.
This product does not replace a motor control box or the need for motor
overload protection. Installation and motor overload protection should be in
accordance with National Electrical Code Article 430 or in accordance with motor
manufacturer's recommendations.
■ Continuous Calibration Memory
■ Works With All Single-phase Motors
■ Transient Surge Protection
■ UL Listed (E104778)
■ Adjustable Automatic Restart Timer
■ Toll-Free Customer Support (800-348-2420)
1/2 to 5 hp
230 VAC*
60 Hz
5 Watts
-15 °F to 140 °F
±10%
±25%**
4 starts/min
2.5 sec
1 min to 4hr 15 min
2 min
3 min
10 years
5 hp